2007 Honda Odyssey Fog Lights Installation Procedures Continued…
20. Locate the subfuse field close to the under-hood fuse relay box. Remove the subfuse box cowl (two tabs).
21. Remove the screw, and disconnect the vehicle harness.
22. Remove the subfuse box from the automobile bracket.
23. Take away the subfuse box from the case (one tab).
24. Get the lengthy subharness. Plug the 1-pin terminal on the lengthy subharness into the rear of the subfuse field at the location shown.
25. Safe the lengthy subharness to the subfuse field harness with one small wire tie.
26. Secure the long subharness to the car harness with one wire tie.
27. Reinstall the subfuse box.
28. Disconnect the car 20-pin connector from the bottom of the underneath-hood fuse relay box.
29. Get the brief subharness. Plug the 1-pin terminal from the brief subharness into the again of the car 20-pin connector.
30. Reconnect the vehicle 20-pin connector into the below-hood fuse/relay box.
31. Disconnect the car 18-pin connector from the back of the below-hood fuse/relay box.
32. Get the fog light harness. Plug the 1-pin white/ inexperienced and the 1-pin red/green terminals into the back of the 18-pin connector in the locations shown.
33. Reconnect the vehicle 18-pin connector into the underneath-hood fuse relay box.
34. Plug the connector on the long/quick subharness into the fog light harness connector. Secure the fog lights harness and the subharness to the car harness with one small wire tie, then trim the wire tie.
35. Reinstall the below-hood fuse relay field decrease cover in the unique position.
36. Beneath the beneath-hood fuse relay field, secure the fog lights harness connector to the automobile harness using the wire tie with holder, and trim the wire tie.
37. Utilizing isopropyl alcohol, thoroughly clean the areas where the cushion tape will attach. Using scissors, lower one cushion tape in half, and attach one half to the FI-ECU within the area shown.
38. Find the car 2-pin connector blue taped to the car harness, and remove the blue tape to free the connector. Plug the fog lights harness 2-pin connector into the automobile harness 2-pin connector.
39. Secure the fog lights harness connector to the automobile harness using one wire tie.
40. Route the fog lights harness forward alongside the vehicle harness. Loosely secure it to the car harness with two wire ties.
